Winchester DGH 45 Guida di Installazione

3.) Venting system shall terminate a minimum of 9.) Figure 4 shows how to vent piping through3 ft. (.9m) above any forced system located a combustible

A regulator is required on the propane tanks.Check inlet supply pressure at the unit and Piping must be gas tight and a non-hardeningupstream of the

meter, making sure all other appliances are If the regulator needs adjustment, the regulator turned off. adjusting screw may be turned clockwise toThe

7. Restart heater by following the light instructions. Electrical ConnectionsSet thermostat to the desired temperature setting.Tabel 6 Manifold Pre

FIGURE 8 DGH WIRING DIAGRAM BEFORE OPERATING UNIT HEATERFollow these on-site pre-operational proceduresbefore putting unit heater into operation:1. T

C. Use only your hand to move the gas controlswitch. Never use tools. If the switch will not move by hand, don't try to repair it, call a quali

TECHNICAL / DIMENSIONS DIMENSIONS (inches / cm)FOR DGH (30, 45, 60, 75) MODELS 30 45 60 75A 26.8 / 68.1 26.8 / 68.1 26.8 / 68.1 26.8 / 68.1B 12.2 / 3

MAINTENANCE 13. Turn gas and electricity back on and set the thermostat high enough to cycle the unit to go 1. Remove the access panel. through a comp

SAFETY DEVICES (Continued) LED DIAGNOSTIC CAPABILITY3) Pressure Switch The red LED on the ignition module indicates theThis is a normally open type sw

19

UNPACKING AND INSPECTION WARNINGS1. Examine unit as received for any Should over heating occur, or the gas damages. If any

WINCHESTER Garage Heater Parts ListingRef # Description DGH 30 DGH 45 DGH 60 DGH 751 Casing Wrapper GH-1001 GH-1001 GH-1025 GH-10252 Cover Panel* GH-1

BL 1 G.V. HOT (24 V)Y 2 PR. SW.3 T-STAT ( W )YRBK BK 5 FAN HOT (F1)BK 6 120 V (L1)L1 Y Y 7 24 V ( R )8 GROUNDL2 BL BL10 ING. (S1)W W 11

1-Year Part Warranty / 10-Year Heat Exchanger Warranty ADAMS LIMITED WARRANTY Adams, manufacturer of WINCHESTER brand garage heaters, referred to as

7. Do maintain a rear clearance of 18" 18. Do not attach duck work, air filters or(45.7cm) or 6" (15.2cm) beyond motor at plastic vent pipe

4

SUSPENSION washers and lock nuts, lock washers and nuts, or a double nut arrangement similarity used on Unit(s) must be supported from the structural

The requirements for combustion and ventilation This unit heater series is equipped with powerair depends on how unit will be installed. That is exha

7. If improper venting is observed during any Unit heaters come with the vent adaptor alreadyof the above tests, the venting system must attached so t

Figure 3B HORIZONTAL THROUGH vented into a masonry (or concrete) chimneyCOMBUSTIBLE WALLlined with material acceptable with recog-nized standards an

Figure 4 Horizontal Venting With Upward C.) Requirements For Horizontal VentingPitch1. Horizontally Vented heaters perform as Category III Applianc